Demilec Insulation Removal Nationwide

Demilec Insulation Removal in San Antonio: What to Know First

Demilec insulation removal in San Antonio typically runs $1,100 to $3,800 depending on square footage, the Demilec line installed, and how thoroughly it’s bonded to the framing. We’re an independent Demilec service provider – not affiliated with the manufacturer – and most removal jobs take one to two days from arrival to final cleanup. If you’re noticing sagging, persistent odor, or moisture retention in your Demilec foam, call (254) 279-0971 and we’ll give you a written price before any work starts.

Call (254) 279-0971

This page is for San Antonio homeowners who have Demilec spray foam or injection foam in their walls or attic and need it out. Whether it’s Heatlok HFO, Sealection 500, or an older APEX series install, the failure modes are specific, and pulling it correctly matters more than most people realize.

Key Takeaways:

• We remove Demilec open-cell and closed-cell foam from attics, walls, and rim joists across San Antonio
• Most jobs take one to two days with full containment and cleanup
• Every quote is written, itemized, and delivered before work begins
• We carry the 365-Day Done Right Promise and a free second visit if anything fails
• You get photo proof of the full removal, not just a verbal “all done”

How Demilec Products Fail – and How We Fix Them

Demilec makes quality foam, but San Antonio’s heat and humidity expose weaknesses that don’t show up in other climates. Here’s what we see on actual jobs across the city:

• Heatlok HFO off-ratio installs. When the A-side and B-side aren’t mixed at the correct ratio, the foam stays soft, tacky, or never fully cures. Homeowners notice a chemical smell that won’t fade. We see this most often in northside additions done by crews rushing in summer heat. The fix is full mechanical removal – scraping, grinding, and vacuum extraction – not covering it with new foam.
• Sealection 500 moisture retention in rim joists. Open-cell foam absorbs water, and in older San Antonio pier-and-beam homes near the river basin, rim joist areas stay damp. The foam holds that moisture against the framing. We remove it, inspect the wood, and advise on closed-cell replacement if the area stays wet.
• APEX series shrinkage and gaps. The older APEX closed-cell line can shrink slightly over a decade, opening air gaps at the top of wall cavities. Homeowners feel drafts but can’t see the problem. Removal gives us access to inspect and re-insulate properly rather than injecting around failed foam.
• Heatlok Soy 200 brittleness in vented attics. In San Antonio attics that hit 140°F plus for months at a time, older Demilec soy-based formulas can become brittle and pull away from OSB. Crumbling foam particles end up in the living space through can-light gaps. This is a full-removal scenario, not a patch job.
• Bad adhesion on dusty or damp substrates. Demilec foam only bonds as well as the surface it’s sprayed on. In San Antonio’s clay-dust environment, an installer who didn’t prep the deck properly leaves you with foam that falls in sheets. We remove the delaminated sections, clean the surface, and discuss whether re-spraying makes sense.

Our Demilec Insulation Removal Process

Every Demilec removal follows the same sequence, whether it’s a 200-square-foot rim joist job or a full attic pull. Chase Whitaker and our crew follow a process that leaves nothing to chance:

1. 1
   Call and diagnosis. You reach a live person at (254) 279-0971. We ask what you’re seeing, hearing, or smelling. If photos help, you send them.
2. 2
   Site visit and foam assessment. We identify the Demilec line, check cure quality, and measure coverage. You get a written price before any work starts.
3. 3
   Containment setup. We seal off the work area, lay down floor protection, and run negative air pressure so foam dust doesn’t travel through your house.
4. 4
   Mechanical removal. We use scrapers, grinders, and HEPA-filtered vacuums to pull the foam down to the deck or stud faces. No chemicals, no shortcuts.
5. 5
   Surface prep and inspection. We inspect the exposed framing for moisture damage, rodent signs, or wiring issues the foam was hiding.
6. 6
   Cleanup and photo proof. We vacuum the space, remove containment, and send you before-and-after photos. You pay from the digital invoice link.

From call to cleanup, a standard attic removal in San Antonio takes one to two days. You’ll never wonder where we are – every job has live arrival tracking through the Relay Standard.

What Demilec Insulation Removal Costs in San Antonio

Here’s what we quote on typical Demilec jobs in the San Antonio market. These are honest ranges, not bait prices:

• Single-room wall removal (200 – 400 sq ft): $1,100 – $2,100
• Full attic under 1,000 sq ft: $1,800 – $2,900
• Attic 1,000 – 2,000 sq ft: $2,600 – $3,800
• Rim joist removal, pier-and-beam: $900 – $1,700
• Crawl space open-cell removal: $1,400 – $2,600

Price moves on three things: how much foam is present, how hard it’s bonded to the surface, and whether we’re working in tight or hot conditions. Delaminated foam that’s already falling off costs less to remove than a properly cured Heatlok HFO layer that’s fully adhered. Every quote is written and itemized, and estimates are free. Call (254) 279-0971 for an exact number on your job.

Why San Antonio Homeowners Call Laurel Attic Insulation San Antonio for Demilec Work

Most insulation companies in San Antonio will remove any foam and call it a day. We approach Demilec differently because we know which lines fail and why. That means faster diagnosis, less guesswork, and a removal plan that doesn’t waste your money on unnecessary demo.

We’re part of the Relay Home Co. family, founded in 2003. Every job carries the Relay Visibility Guarantee – a written price before work starts, live arrival tracking, and photo proof of every step. Our techs are background-checked and uniformed, and they arrive at a trackable time, not a four-hour window. If the removal isn’t done right, the 365-Day Done Right Promise covers it in writing. If the repair fails, you get a free second visit, no charge, no argument.

We also stock materials from Owens Corning, Rockwool, Icynene, CertainTeed, and GreenFiber – and yes, we can re-insulate with Demilec if you want to stay with the brand, or install Reflectix in specific applications where radiant barrier makes more sense for the San Antonio sun. A comfortable attic isn’t a luxury in San Antonio – it’s just a house that works the way it should.

FAQs